IQOS Iluma One - a user guide

*Please note that the ILUMA ONE and ILUMA kits have slightly different setups.

The ILUMA ONE's packaging comes with a step-by-step guide to get started, but here's a summary for you:

ILUMA ONE Setup Instructions

The setup process for the ILUMA ONE is very similar to that of other ILUMA devices, with just a few minor differences due to its all-in-one design.

1. Firstly, ensure the device is fully charged using your kit's official IQOS mains plug and cable. You can quickly press the power button to check your battery status. It can take up to 90 minutes for the battery to fully charge from empty.
2. Turn it on by holding the button for 4 seconds. 
3. Slide open the metal cap and insert a TEREA stick up to the line shown on the filter. 
4. Hold the button for 1 second until the device vibrates and the light pulses. Keep the TEREA stick inserted during this preheating phase.
5. To begin using your device, wait until it vibrates and the lights stop flashing. When the lights stay steady, it's ready to use. Inhale gently from the mouthpiece as if smoking a cigarette. Each session provides 14 puffs.
6. When only 30 seconds/2 puffs remain, the device will vibrate twice, and the light will flash white to signal nearing the end of the session.
7. Remove and dispose of the TEREA stick and slide to close the cap.

To note: 

• The session will stop if the TEREA stick is removed from your IQOS ILUMA ONE.
• If the ambient temperature falls out of range (0℃⁓40℃), white lights will blink twice, and then the device will switch off until it is warmed up or cooled down.

Something not working with your Iluma One?

Please see our Iluma One Trouble Shooting Guide for problem solving tips.